Table of Contents
Advertisement
6.1.12 Make sure the Programmer shows the correct file and correct part in the JTAG chain and
check the Program/Configure checkbox.
6.1.13 Click Start to program the CYC1000. When the configuration is complete, the Progress bar
should reach 100% (Successful).
The design is now programmed to the FPGA.
Note: that turning off and then on the FPGA will result into losing its configuration.
6.2 Serial configuration flash memory programming
The configuration data to be written to EPCQ-A will be part of the JTAG indirect configuration file
(.jic). This configuration data is automatically loaded from the serial configuration flash into the
Cyclone 10 LP device when the board is powered up.
CYC1000 User Guide
Page | 57
www.arrow.com
January 2020
- Quick Links:
- Sdram Memory
- Figure 13 - Uart Connections
Hide quick links:
Advertisement
Table of Contents
