The next step is to compile and complete the design. This step will verify that there are
no errors, create internal databases, and create programming files that will be used in
the next steps.
5.2.14.2 To compile the design, select Processing → Start Compilation or push the
the toolbar.
If there are errors, they will need to be resolved and re-compiled before the design can
be programmed to the board. When Compiling finishes and there are no errors, there
will be a message at the bottom of the window that states: Full Compilation was
successful and a 100% indication along with the compile time in the right bottom corner.
5.2.15 Reading the Compilation Report
After successfully compiling the design, a Compilation Report should appear as shown above:
CYC1000 User Guide
Page | 52
button on
www.arrow.com
January 2020