Arrow CYC1000 User Manual page 27

In the Family and Device Settings, use the pull-down menu to select the family as Cyclone
10 LP. Then in the Name Filter enter 10CL025YU256C8G.
Rather than entering the exact part number, the pull-down menus can be used to select
the correct family, package, pin count, and speed grade. Quartus Prime will use these
settings to compile the design, and also provide the programming file that you will use
later to program the device.
5.1.12 Click "Next".
5.1.13 EDA Tool Settings
In the EDA tool Settings window, disable any EDA tools, if there are any present. EDA tools
are third party tools that work with Quartus Prime for design entry, simulation,
verification and board-level timing. For this tutorial, no EDA software will be used, as only
Quartus Prime will be used.
CYC1000 User Guide
Page | 27
www.arrow.com
January 2020