Summary of Contents for Arrow verical LINEAR TECHNOLOGY DC1762A-A
Page 1
Los Angeles, CA 90074-0970 This coversheet was created by Verical, a division of Arrow Electronics, Inc. (“Verical”). The attached document was created by the part supplier, not Verical, and is provided strictly 'as is.' Verical, its subsidiaries, affiliates, employees, and agents make no representations or warranties regarding the attached document and disclaim any liability for the consequences of relying on the information therein.
DEMO MANUAL DC1762A LTC2165, LTC2164, LTC2163 LTC2162, LTC2161, LTC2160, LTC2159, LTC2269 16-Bit, 20Msps to125Msps ADCs Description Demonstration circuit 1762A supports a family of 16-Bit Depending on the required resolution and sample rate, 20Msps to 125Msps ADCs. Each assembly features one the DC1762A is supplied with the appropriate ADC.
DEMO MANUAL DC1762A Quick start proceDure Demonstration circuit 1762A is easy to set up to evaluate DC1762 Demonstration Circuit Board Jumpers the performance of the LTC2165 A/D converter family. Refer The DC1762A demonstration circuit board should have to Figure 1 for proper measurement equipment setup and the following jumper settings as default positions: (as follow the procedure below: per Figure 1)
Page 4
DEMO MANUAL DC1762A Quick start proceDure Applying Power and Signals to the DC1762A IC based operational amplifiers may be unable to deliver Demonstration Circuit the combination of low noise figure and High IP3 point required. A high order filter can be used prior to this final If a DC890 is used to acquire data from the DC1762A, amplifier, and a relatively lower Q filter used between the the DC890 must FIRST be connected to a powered USB...
Page 5
DEMO MANUAL DC1762A Quick start proceDure Software The DC890 is controlled by the PScope System Software provided or downloaded from the Linear Technology website at http://www.linear.com/software/. If a DC890 was provided, follow the DC890 Quick Start Guide and the instructions below. To start the data collection software if PScope.exe, is in- stalled (by default) in \Program Files\LTC\PScope\, double click the PScope icon or bring up the run window under...
Page 6
DEMO MANUAL DC1762A Quick start proceDure Clock Inversion: Selects the polarity of the CLKOUT signal: • Normal (Default): Normal CLKOUT polarity • Inverted: CLKOUT polarity is inverted Clock Delay: Selects the phase delay of the CLKOUT signal: • None (Default): No CLKOUT delay • 45 deg: CLKOUT delayed by 45 degrees • 90 deg: CLKOUT delayed by 90 degrees • 135 deg: CLKOUT delayed by 135 degrees Clock Duty Cycle: Enables or disables duty cycle stabilizer • Stabilizer off (Default): Duty cycle stabilizer disabled • Stabilizer on: Duty cycle stabilizer enabled Output Current: Selects the LVDS output drive current...
Page 7
DEMO MANUAL DC1762A Quick start proceDure Output Mode: Selects digital output mode Alternate Bit: Alternate Bit Polarity (ABP) Mode • Full Rate: Full rate CMOS output mode (This mode is • Off (Default): Disables alternate bit polarity not supported by the DC1762A) • On: Enables alternate bit polarity (Before enabling ABP , • Double LVDS (Default): Double data rate LVDS output be sure the part is in offset binary mode) mode Randomizer: Enables Data Output Randomizer • Double CMOS: Double data rate CMOS output mode...
DEMO MANUAL DC1762A schematic Diagram dc1762afb Information furnished by Linear Technology Corporation is believed to be accurate and reliable. However, no responsibility is assumed for its use. Linear Technology Corporation makes no representa- tion that the interconnection of its circuits as described herein will not infringe on existing patent rights.
Page 11
DEMO MANUAL DC1762A DEMONSTRATION BOARD IMPORTANT NOTICE Linear Technology Corporation (LTC) provides the enclosed product(s) under the following AS IS conditions: This demonstration board (DEMO BOARD) kit being sold or provided by Linear Technology is intended for use for ENGINEERING DEVELOPMENT OR EVALUATION PURPOSES ONLY and is not provided by LTC for commercial use.
Need help?
Do you have a question about the verical LINEAR TECHNOLOGY DC1762A-A and is the answer not in the manual?
Questions and answers