Installing Arrow Usb Programmer2 - Arrow CYC1000 User Manual

4.1.6 After the download is finished, run the Quartus Prime installer.
4.1.7 When prompted to select the components, the installer will detect automatically the
Cyclone 10 LP device support and ModelSim packages when they are in the same folder.
Make sure these components are selected:
4.1.8 Finish the installation of the Quartus Lite and proceeded to the next section to install
Arrow USB Programmer2 to be able to connect to the CYC1000 board.

4.2 Installing Arrow USB Programmer2

The CYC1000 board uses version 2 of the Arrow USB Programmer2 programming solution, that is
an FTDI FT2232H Hi-Speed USB controller plus a programmer DLL. Since this FTDI USB controller
is a very common standard device, usually no specific drivers are needed to make the CYC1000
work.
CYC1000 User Guide
Page | 21
www.arrow.com
January 2020