Flashforge Creator 3 User Manual page 45

[Setting]-[Calibration]
Calibration includes Z axis calibration,Y axis calibration and X axis calibration.For details see Page 19.
[Setting]-[Light Bar Contril]
Turn on or off flash/ ambient light; light brightness can be adjusted according to your demands.
[Setting]-[Factory Reset]
Turn on this function, the device state restored to the factory fault setting.
[Setting]-[Update]
Tap[update]when device connected to WLAN network.The device will update to the latest version automatically when
needed.Reboot the device after update completed.
Note: Do not cut off power and network, or printing fails.
44