Flashforge Creator 3 User Manual page 19

3. When extruder heated up to the target temperature,press down the spring presser with left hand, and insert filament
into filament intake until filament drive gear starts to load filament. Let white filament go,and insert white filament
guidetube into extruder filament intake.
4. Wait for even filament from nozzle. If is filament changing, please wait for same color of filament, then stop loading.
Note: Please loading before inserting filament into filament guidetube.Insert filament guidetube into filament intake
after loading completed.
1. Tap [Tools]-[Filament]-target extruder[Unload] in turns on the touch screen, wait for extruder heating up.
2. When extruder heated up to the target temperature, wait for even filament from nozzle.Now,press down spring
presser with left hand, pull out white filament guide tube with right hand, pull out filament quickly,unloading complet-
ed.
[Unloading]
18
Withdraw
Filament
Guidetube
Press here
Push filament
down through
for 3 seconds