Flashforge Creator 3 User Manual page 22

R
L
Deviation of two straight line
3. If two lines coincide completely,tap[Yes],X axis calibration completed.
[Y axis calibration]
By comparing if printing lines of two extruders coincide in the direction of Y axis to judge if two extruders in the same
Y axis.
1. Tap[Y axis calibration],wait for two extruders heating up to the target temperature, two extruders print one line in
turns.After printing completed,check if two lines coincide; In the meanwhile, a confirmation notice pops up.
2. If two lines coincide completely,tap[Yes],Y axis calibration completed.
3. If two lines not coincide completely,tap[No],adjust extruder position according to actual situation.After adjustment
completed,clean filament on the build plate,tap[Recalibration];Repeat step1 and step2 until two printed lines coincide.
R
L
Two straight lines coincide
21
Please click the icon as shown in the picture and
adjust the nozzle with the left nozzle as the indicator.
Estimate the deviation.Enter the estimated value and
click "recalibrate";Repeat the above steps until the
two lines coincide.