Flashforge Creator 3 User Manual page 43

11. Light Bar Control: To turn on/off the light bar control;
12. Factory Reset: Return to factory setting;
13. Update: To update the firmware version;
14. Platform Heat Preservation: When the printing finished, the platform will keep heating the current setting time；
15. Test Extruder Sensor:
16. Steel Brush /Rubber：
[Setting]-[language]
Tap [language]to enter language setting interface
1. Tap to choose the display language.
2. Page turning: Turn to the up/down menu
[Setting]-[WiFi]
Turn on WiFi function, the device can connect to network:
1. Remote file transfer and print.For details, see page 29 network transfer print.
2. Remote control device print state,for details, see page 34 WiFi connection camera.
[Setting]-[WLAN hotspot]
Turn on WLAN hot-spot function, the device can connect to PC hot-spot:
1. Remote file transfer and print,for details, see page 30 hotspot connection print.
2. Remote control device print state,for details, see page 33 WLAN hotspot connection camera.
42