Adding a telephone
You must connect, configure and test the telephone before adding the telephone to the Avaya
G350 Media Gateway.
Connect the telephone
To connect a new telephone, see one of the following sections:
Connecting an IP telephone
●
Connecting an analog telephone
●
Connecting a DCP telephone to an MM312, MM712, or MM717 media module
●
Configure the telephone on the G350
Configuration may be performed on site by connecting a laptop computer connected to the
CON port of the G350, or remotely via a modem connected to the G350 or S8300.
For information about preparing a modem, see
for remote access
the G350
on page 79
Record telephone information for software configuration
When you add a new telephone, note the following information for software configuration:
Name and location of the owner of the telephone
●
Model number of the telephone
●
Extension of the telephone
●
Slot and port number on the Avaya G350 Media Gateway to which the telephone connects
●
Test the telephone
1. Make outgoing calls from the telephone. Make sure you hear a dial tone when you pick up
the receiver. Make sure you can make both an internal (within the local network) and an
external (outside of the local network) call.
2. Make a call to the telephone from both within the network and outside of the network.
on page 48
on page 50
on page 61. For information about configuration, see
Chapter 4: Connecting and enabling a modem
Adding a telephone
on page 52
Chapter 5: Configuring
Issue 4 February 2007
87