Adding media modules and devices
There is no configuration necessary when you add or remove a WAN module. Configuration is
only necessary when you add WAN lines to the new module. See
page 77.
Adding a telephone
You must connect, configure and test the telephone before adding the telephone to the Avaya
G450 Media Gateway.
Connecting the telephone
To connect a new telephone, see the following sections:
Connecting an IP telephone
●
Connecting an analog telephone
●
Connecting a DCP telephone to an MM712 or MM717 media module
●
Configuring the telephone on the Communication Manager
Standalone: Configuration may be performed on site by connecting a laptop computer to
●
the Console port or Services port of the G450 or S8300, or remotely via a modem
connected to the G450 or S8300.
LSP: Configuration is done on the primary CM server.
●
For information about connecting a laptop to the Services port, see
the Services port
Chapter 4: Connecting and enabling a modem for remote access
about configuration, see
Recording telephone information for software configuration
When you add a new telephone - IP, DCP or Analog - note the following information for software
configuration:
Name and location of the owner of the telephone
●
Model number of the telephone
●
Extension of the telephone
●
Slot and port number on the Avaya G450 Media Gateway to which the telephone connects
●
(this does not apply to IP telephones).
74 Installation and Upgrades for the Avaya G450 Media Gateway
on page 44
on page 43. For information about preparing a modem, see
Chapter 5: Configuring the G450
on page 46
on page 67.
Adding a WAN line
on
on page 48
Connecting a computer to
on page 59. For information