Install The Center Rack Control - Raven AutoBoom Installation Manual

Install the Center Rack Control

Machine's Center Boom Function Coils
FIGURE 2.
Locate the Center Up coil on the machine's hydraulic valve.
1.
Unplug the coil connector from the Center Up coil.
2.
Install a center rack control adapter cable (P/N 115-0230-077) on the machine's Center Up coil.
3.
Connect the machine's coil connector to the 3-pin end of the installed boom sense adapter cable.
4.
Connect the female end of the installed adapter cable to the Control harness connection.
5.
Plug the male end of the installed adapter cable to the Sense harness connection.
6.
Locate the Center Down coil on the machine's hydraulic valve.
7.
Unplug the coil connector from the Center Down coil.
8.
Install a center rack control adapter cable (P/N 115-0230-077) on the machine's Center Down coil.
9.
Connect the machine's coil connector to the 3-pin end of the installed boom sense adapter cable.
10.
Connect the female end of the installed adapter cable to the Control harness connection.
11.
Plug the male end of the installed adapter cable to the Sense harness connection.
12.
Manual No. 016-0230-009 Rev B
Wiring
23