1.
INSTALL THE APPLICATION
1.1 General Information
This section describes a standard application commissioning procedure.
The preliminary operations for commissioning ADL300 drives are described in chapter 8 of the "ADL300
Quick Start Guide".
1.2 Requirements
The EPC application for ADL300 requires firmware version 2.00.
EPC application).
To install the application you must have a PC, version 1.6.5 or higher of the Gefran GF_eXpress software
with Catalog, the RS-485 serial interface cable (cod
The application set-up file
folders of the GF_eXpress
1.3 Preliminary operations
The EPC application is preloaded in the drive as Application 2
Application sel).
Once GF_eXpress is installed
•
Select the ADL300A (Asynchronous) or ADL300S (Synchronous) Lift drive.
Selezionare la versione dell'applicazione:
•
•
ADL300S: 4.x.4 EPC 7.x.10.0 (EPC for Synchronous Motors)
•
ADL300A: 4.x.4 EPC 7.x.10.0 (EPC for Asynchronous Motors)
ADL300-EPCv2- User Guide
contains an automatic procedure that copies the required files in the specific
catalog.
perform the following procedure:
____________________ _
or higher
8S864C).
(refer to the menu parameter 4.5 PAR 558
(Releases 1.x do not support the
Page 6 of 64