gefran ADL300 EPC v2 User Manual page 32

When set to 0 the contactor sequences can be enabled without sending the Enable command (Enable is
only needed for motor operation). The enable signal can be sent by an auxiliary contact of the output
contactors.
If set to 1 the contactor sequences can only be enabled if the enable command is active.
Menu Par Description
5.4.2 11062 Cont Close Delay
Setting of the delay for closing the contactor.
Menu Description
Par
5.4.3 11064 Brake open delay
Setting of the delay for opening the brake.
Menu Par Description
5.4.4 11068 Brake close delay
Setting of the delay for closing the brake.
Menu Description
Par
5.4.5 11070
Current Ramp Down Delay
Setting of the time needed to reduce the torque from the threshold value active during travel to 0. It defines
the slope of the downward ramp in the "Rampa dimin corrente" function. The purpose of this function is to
prevent immediate removal of motor torque upon application of the brake, which would cause undesirable
stress on the inside of the lift car.
To avoid this phenomenon, after applying the brake the current limits are brought to the current value in use
and then ramped down.
The function is enabled when Current down delay is set to a value other than zero.
This is only possible when Torque curr lim sel (PAR 2354) has a value other than "OFF", otherwise
Current ramp down delay is forced to zero.
Menu Par Description
5.4.6 11072 Cont open delay
Setting of the delay for opening the contactor.
Menu Description
Par
5.4.7 11078 Speed 0 Threshold
Setting of the zero speed threshold, below which the zero speed signal is activated
Menu Par Description
5.4.8 11080
Speed 0 Delay
Setting of the zero speed delay. After the zero speed signal and after the delay set in this parameter the zero
speed signal is enabled. These parameters are used to know the lift car stop.
Menu Par Description
5.4.9 11086 Door Open Speed
Setting of the door open speed. This function is used to control door opening in advance before the lift car
arrives at the floor. The door open signal can be relayed to a digital output when the speed is below the user-
definable threshold. The function must be enabled from the digital input. The state of execution of the speed
control command for opening the door can be checked by sending the feedback from the door opening
mechanism to the digital input of the drive.
An alarm may be generated if the command and feedback do not coincide.
ADL300-EPCv2- User Guide
UM Type
ms INT32
UM Type
ms INT32
UM Type
ms INT32
UM Type
ms INT32
UM Type
ms INT32
UM Type
rpm INT16
UM Type
ms UINT16
UM Type
m/s FLOAT
____________________ _
FB BIT Def Min
200
FB BIT Def Min
200 0
FB BIT Def Min
200 0
FB BIT Def Min
0
FB BIT Def Min
200 0
FB BIT Def Min
1
FB BIT Def Min
0 0
FB BIT Def Min
0.0010
Max Acc
0 10000 RW
Max Acc
10000 RW
Max Acc
10000 RW
Max Acc
0 10000 RW
Max Acc
10000 RW
Max Acc
RW
Max Acc
10000 RW
Max Acc
RW
Page 32 of 64
Mod
FVS
Mod
FVS
Mod
FVS
Mod
FVS
Mod
FVS
Mod
FVS
Mod
FVS
Mod
FVS