gefran ADL300 EPC v2 User Manual page 30

Menu Par Description
5.3.4 11014 Dec ini jerk
Setting of the jerk value for the initial part of deceleration.
Menu Par Description
5.3.5 11016 Deceleration
Maximum deceleration value setting.
Menu Par Description
5.3.6 11018 Dec end Jerk
Setting of the jerk value for the final part of deceleration.
Menu Par Description
5.3.7 13184 PercAccFactor
Setting of the acceleration coefficient multiplier.
If set to 100 the ramp uses the coefficients entered in the parameters.
If set to a value of less than 100 the lift will accelerate over a longer distance.
If set to a value of more than 100 the lift will accelerate over a shorter distance.
Menu Par Description
5.3.8 13186 Perc Dec Factor
Setting of the deceleration coefficient multiplier.
If set to 100 the ramp uses the coefficients entered in the parameters.
If set to a value of less than 100 the lift will decelerate over a longer distance.
If set to a value of more than 100 the lift will decelerate over a shorter distance.
05.04 – SEQUENCES
This menu contains the parameters used to manage and define the travel of the lift according to the status of
the inputs and alarms. The structure of the lift sequences in case of a floor call command is summarised
below. Once the command has been received and the number of the floor to be reached has been saved,
the internal positioning device starts and automatically executes the trajectory until reaching the floor with
direct arrival.
In case of jog speed the deceleration sequence starts the moment the jog command is removed.
Starting sequence:
1. Reading of the Enable hardware input and alarm check (enabling is interrupted if any alarms are
present)
2. Recognition of the Enable and Floor Call commands as set in Seq start mode
3. Upon receiving the Floor Call command, the number of the floor to be reached is acquired by
reading the binary combination of the Floor0, Floor1, Floor 2... bits as a function of the direction of
travel. A command is sent to close the contactors
4. After the time set Contactor close delay the internal Enable signal is activated
5. The system waits for the magnetisation signal from the drive (Drive Ready)
6. After magnetisation the signal is activated to release the brake
7. The system waits for the brake to be released (Contactor Open Delay)
8. After the brake release delay the Lift Start command is sent and the movement is enabled.
ADL300-EPCv2- User Guide
UM Type
m/s3 FLOAT
UM Type
m/s2 FLOAT
UM Type
m/s3 FLOAT
UM Type
Perc FLOAT
UM Type
Perc FLOAT
____________________ _
FB BIT Def Min
1.400 0.001
FB BIT Def Min
0.600 0.001
FB BIT Def Min
0.500 0.001
FB BIT Def Min
100.0 0.0
FB BIT Def Min
100.0 0.0
Max Acc Mod
20 RW FVS
Max Acc Mod
10 RW FVS
Max Acc Mod
20 RW FVS
Max Acc Mod
1000.0 RW FVS
Max Acc Mod
1000.0 RW FVS
Page 30 of 64