gefran ADL300 EPC v2 User Manual page 42

05.07 – LIFT OUTPUTS
Lift control output signals are connected directly to the PAD parameters. See table in chapter 6.6 Outputs.
The set of lift output signals is comprised in two LiftStatusWords, see chapter 6.7.
Menu Par Description
5.7.1 11450 Sel Status Word1
Setting of the source for "lift status word 1":
0 Pad11
1 Pad12
Menu Par Description
5.7.2 11452 Sel Status Word2
Setting of the source for "lift status word 2":
0 Pad11
1 Pad12
Menu Par Description
5.7.3 12030 Status Word 1
Status word 1 is displayed as a hexadecimal value, see the description of "lift status word 1" for the
meaning of each bit
Menu Par Description
5.7.4 12214 Status Word 2
Status word 2 is displayed as a hexadecimal value, see the description of "lift status word 2" for the
meaning of each bit
05.08 – LIFT MONITOR
This menu contains some display parameters that are useful for verifying correct control functioning.
Menu Par Description
5.8.1 12010 Calculation Mode
The calculation mode is displayed:
0 Direct mode
1 Mechanical data
Menu Par Description
5.8.2 12012 Actual spd reference
The current speed reference value is displayed in m/s
Menu Par Description
5.8.3 12028 Actual spd reference
The current speed reference value is displayed in rpm
Menu Par Description
5.8.4 12084 Rated Torque
The nominal torque value is displayed
Menu Par Description
5.8.5 12090 Trip Number
The number of strokes performed by the control device is displayed
ADL300-EPCv2- User Guide
UM Type
ENUM
UM Type
ENUM
UM Type
UINT32
UM Type
UINT32
UM Type
INT16
UM Type
m/s FLOAT
UM Type
rpm FLOAT
UM Type
Nm FLOAT
UM Type
INT32
____________________ _
FB BIT Def Min
0
FB BIT Def Min
1
FB BIT Def Min
500
FB BIT Def Min
0
FB BIT Def Min
0
FB BIT Def Min
0.0000
FB BIT Def Min
0.0000
FB BIT Def Min
- -
FB BIT Def Min
0.0000
Max Acc Mod
RW FVS
Max Acc Mod
RW FVS
Max Acc Mod
R FVS
Max Acc Mod
R FVS
Max Acc Mod
R FVS
Max Acc Mod
R FVS
Max Acc Mod
R FVS
Max Acc Mod
- R FVS
Max Acc Mod
R FVS
Page 42 of 64