gefran ADL300 EPC v2 User Manual page 45

If set to 0 the brake feedback alarm is signalled immediately.
If set to 1 the possible brake feedback alarm is signalled at the end of the travel: this allows the lift car to
reach the floor in case of a faulty brake status signal.
Menu Description
Par
5.9.8 11574 Brake hold off
Setting of the delay between the signalling of the Brake Feedback alarm condition and activation of the
alarm. If an alarm condition occurs, the drive will wait for the set time before activating the alarm. If the
alarm is removed within the time set in this parameter, the drive will not activate it.
Menu Par Description
5.9.9 11576 Cont hold off
Setting of the delay between the signalling of the Contactor Feedback alarm condition and activation of
the alarm. If an alarm condition occurs, the drive will wait for the set time before activating the alarm. If
the alarm is removed within the time set in this parameter, the drive will not activate it.
Menu Par Description
5.9.10 11578 Door Hold off
Setting of the delay between the signalling of the Door Feedback alarm condition and activation of the
alarm. If an alarm condition occurs, the drive will wait for the set time before activating the alarm. If the
alarm is removed within the time set in this parameter, the drive will not activate it.
ADL300-EPCv2- User Guide
UM Type
ms INT16
UM Type
ms INT16
UM Type
ms INT16
____________________ _
FB BIT Def Min
1000
FB BIT Def Min
1000
FB BIT Def Min
1000
Max Acc Mod
RW FVS
Max Acc Mod
RW FVS
Max Acc Mod
RW FVS
Page 45 of 64