Table of Contents
Advertisement
The figure below shows a possible alternative cam and sensor layout. This second method is functionally
identical to that illustrated on the previous page but simpler to install and service. For further details please
see appendix B.
Sensor B
Line of the floor
Positive direction
LC => LunghezzaMinimaCamma
d1 = d2
z1, z2, z3 >= LC / 2
Landing Zone = (LC / 2) * 3
ADL300-EPCv2- User Guide
Sensor A
Length of cam A and of cam B.
Distance between the upper edge of cam A and the line of the floor.
Distance between the lower edge of cam B and the line of the floor.
Dimension of an acquisition zone.
This value must be greater than or equal to LunghezzaMinimaCamma / 2.
Dimension of the landing zone
____________________ _
d1
LC
d2
Landing zone cam
z1
z1
Landing
z2
Zone
z2
Page 12 of 64
Advertisement
Table of Contents
