Low Latency; Opt Mode - NovaStar NovaPro UHD User Manual

Figure 4-27 System architecture
Figure 4-28 HDR effect
Step 2
Choose Advanced Functions > HDR > Status to turn on the HDR function.
Step 3
Rotate the knob to adjust the value of each parameter to improve the image quality.
Menu
Peak Screen Brightness
Ambient Brightness
Low Grayscale Mode
Step 4
(Optional) Select Reset to reset all the parameters to default values.
Note:
Currently only HDR10 input source is supported.

4.8.2 Low Latency

Low latency reduces the input source signal latency from input to output image of the NovaPro UHD. This
function can reduce the latency from sending card to receiving card by 2 frames when the device is used
together with NovaStar A5 or later receiving cards.
Note:
The loading width of a single Ethernet port should be no greater than 512 pixels when low latency function is
enabled.

4.8.3 OPT Mode

The NovaPro UHD supports two OPT modes: Hot Backup (default) and Copy.
www.novastar.tech
Description
Adjust the screen brightness under normal operation. The range is 100–1000
and the default setting is 1000.
Display the ambient brightness. The range is 0–200 and the default setting is 30.
Adjust the grayscale value of the image displayed on the LED screen. The range
is 0–50 and the default setting is 15.
NovaPro UHD All-in-One Controller User Manual
18