Set Low Latency; Set Bit Depth; Set Sync Source - NovaStar MX Series User Manual

6.4.3 Set Low Latency

The low latency function is used to reduce the delay at the controller, or increase the latency when the device works
with high-latency equipment.
On the main menu screen, choose Advanced Functions > Output Settings.
Figure 6-12 Low latency
Perform any of the following operations as required.

Enable low latency
Set the Low Latency switch to

Set additional frame latency
a.
Select Additional Frame Latency and press the knob to let the value become editable.
b.
Rotate the knob to adjust the parameter to the target value, and then press the knob to confirm.
Note

The latency at the controller is 0 frame (less than 1 ms) in Send-Only Controller working mode and 1 frame in
All-In-One Controller working mode.

To enable the low latency function, the sync source must be the active input source.

6.4.4 Set Bit Depth

Set the output bit depth of the input source.
On the main menu screen, choose Advanced Functions > Output Settings.
Figure 6-13 Bit depth
Select Bit Depth and then select the desired bit depth value from the drop-down options.
If Auto is selected, the output bit depth is the same as the input bit depth.

6.4.5 Set Sync Source

Select a synchronization signal for the display frame rate and set the phase offset.
On the main menu screen, choose Advanced Functions > Output Settings > Sync.
www.novastar.tech
to enable the low latency function.
MX30 LED Display Controller User Manual
18