Adding Layers - NovaStar NovaPro UHD User Manual

d. Click Apply to save the newly-added BKG files to the software library.
Applying BKG files

Select the desired BKG file and click the file to add it to PVW.

5.3.4 Adding Layers

Step 1
Click to select a signal source on the left.
Right click the edit icon on the right of the signal source to rename the signal source.
Step 2
You can click the video editing area and drag the mouse to create a custom-sized layer.
You can also select a signal source and drag it to the video editing area, and then release the mouse to create
a layer.
When you move the mouse to any edge of the layer and a double-headed arrow appears, you can click and

drag the layer edge to adjust the layer size.
When you move the mouse to the layer area, you can click and drag the layer to change its position.

When a single layer is selected, you can press the arrow buttons to fine tune the layer position, while hold

down the Shift key and press the arrow buttons to fine tune the layer size.
When you move the mouse to the layer top, five buttons appear in the top right corner of the layer. The

detailed button functions are shown in
Layer buttons
Table 5-5
Icon Description
Fit the layer to the screen loaded by the current connector.
Fit the layer to the whole output screen.
Close the layer.
Enable the pixel-to-pixel display mode.
Unlock the layer.
Lock the layer.
You can right click the layer to perform the following operations:
Switch Source: Change the signal source of the layer.

Bring to Front: Bring the layer to the front.

Send to Back: Send the layer to the back.

Bring Forward / Send Backward: Move the layer forward or backward.

Lock Layer / Unlock Layer: Lock or unlock the layer.
Close Current Layer: Close the selected layer.

Close All Layers: Close all the layers.

Setting layer properties
You can configure the layer properties in the property setting area on the right. In this area, you can configure
the layer properties through Layout, Color and Advanced.
Layout

Parameter
Aspect Ratio
Aspect Ratio
Layer
www.novastar.tech
Table 5-5.
Description
Set the proportional relationship between the layer width and its height.
After the layer size is adjusted manually, if the aspect ratio does not match any of
the listed ratios, the aspect ratio will be Custom.
NovaPro UHD All-in-One Controller User Manual
37