Low Latency; Opt Mode - NovaStar NovaPro UHD Jr User Manual

NovaPro UHD Jr All-in-One Controller
User Manual
Figure 5-22 HDR effect
Step 1 Choose Advanced Functions > HDR > Status to enable the HDR function.
Step 2 Rotate the knob to adjust the value of each parameter to improve the image quality.
Menu
Peak Screen Brightness
Ambient Brightness
Low Grayscale Mode
Step 3 (Optional) Select Reset to reset all the parameters to default values.
Note:



5.8.2 Low Latency

Low latency reduces the input source signal latency from input to output image of the
NovaPro UHD Jr. This function can reduce the latency from sending card to receiving
card by 2 frames when the device is used together with NovaStar Armor series
receiving cards.
Note:



5.8.3 OPT Mode

The NovaPro UHD Jr supports two OPT modes: Hot Backup (default) and Copy.


Hot Backup
Step 1 Perform the hardware connections for hot backup mode.
www.novastar.tech
Only HDR10 input source is supported.
When HDR function is enabled, the output loading capacity will be reduced by
50%.
The loading width of a single Ethernet port should be no greater than 512 pixels
when low latency function is used.
The supported Armor series receiving cards include A8, A8s, A9s and A10s Plus.
Hot Backup: Optical fiber ports 3/4 backup the data of optical fiber ports 1/2.
Copy: Optical fiber ports 3/4 copy the data of optical fiber ports 1/2.
Description
Adjust the screen brightness under normal operation.
The range is 100–1000 and the default setting is 1000.
Display the ambient brightness. The range is 0–200
and the default setting is 30.
The range is 0–50 and the default setting is 15.
5 Menu Operations
25