Low Latency - NovaStar MCTRL660 PRO User Manual

6.7.9 Low latency


Supports a low latency of less than 1 ms (when the start position of image is 0). Low latency is used to reduce
the time delay between the input of video signal to the controller and the corresponding output. The loading
width of a single Ethernet port should be no greater than 512 pixels when low latency function is enabled.

Low latency cannot be enabled with any of the following functions at the same time.
−
Image mirroring
−
Interlaced SDI video sources
−
GENLOCK

To use the low latency function, you must ensure that each Ethernet port loads the cabinets vertically during
screen configuration, as shown in
Figure 6-22 Ethernet port loading cabinets vertically
System Settings
Figure 6-23 System settings
Factory Reset
Reset the controller parameters to factory settings.
Return to Home (s)
Set the time of staying on the current screen before going back to the home screen when no action is
performed. The time range is 30s to 3600s.
OLED Brightness
Adjust the brightness of the OLED menu screen on the front panel. The brightness range is 6 to 15.
www.novastar.tech
MCTRL660 PRO Independent Controller User Manual
Figure 6-22.
22