To change the metering mode on the web remote:
1. Connect to the device remotely (see: Section 8.5.1, "Finding the Device on a Network").
2. Locate the visual feedback tab in the STATE section.
3. Push the Peak or RMS button in the global metering settings.
This is a global setting which affects both the front panel level meters and the remote
control interface.
8.4.3. Persistent Clipping Notifications and Peak Hold
The maximum level of signals can be saved and shown on the front panel and web remote. Clipping is
detected when three consecutive samples reach digital full scale (0 dBFS). The duration of how long the
maximum level or clipping is shown can be manually changed to either five seconds or until they are
manually reset.
This is a global setting which affects both the remote control and the device.
To switch over notifications on or off:
1. Open the visual feedback tab in the STATE section
2. Change OVR Hold to either:
◦ 5s to notify for five seconds
◦ On to notify until manually reset
◦ Off to deactivate over notifications.
To reset infinite full scale notifications:
1. Open the visual feedback tab in the STATE section.
2. Activate Reset.
The remote shows an over notification above the level meter, both in miniature port level meters and the
larger level meters when a port is open.
To switch persistant over notifications on or off:
1. Locate the Visual Settings Tab.
2. Change Peak + OVR Hold to either
◦ 5s to notify for five seconds
◦ On to notify until manually reset
◦ Off to deactivate over notifications
To reset over notifications:
1. Within the Visual Settings Tab, use the ⟲ reset button.
RME M-1610 Pro User's Guide
On the device, an over notification is shown above the level meters on the
display.
8.4. Front Panel Illumination | 34