Table of Contents
Advertisement
3. Push the "Peak" or "RMS" button in the global metering settings.
8.4.3. Persistent Clipping Notifications
In multi-channel applications, it can be important to find out which channel clipped. A clipping is
detected when three consecutive samples are digital full scale (0 dBFS). The duration of how long a
clipping ("over") event is shown can be manually changed to either five seconds or infinite.
This is a global setting which affects both the remote control and the device. On the web
remote, an additional peak hold is shown in the level meters.
On the device, an over notification is signaled as a fast flashing (red) of the label
backlight.
Switching over notifications on or off:
1. Open the visual feedback tab in the STATE section
2. Change OVR Hold to either:
◦ 5s to notify for five seconds
◦ On to notify until manually reset
◦ Off to deactivate over notifications
To reset infinite full scale notifications:
1. Open the visual feedback tab in the STATE section.
2. Activate Reset.
8.4.4. Metering of Digital Input Signals
The digital input signals can be visually inspected to ensure that audio signals are reaching the device.
To temporarily assign the 32 front panel level meters to a digital input, open the INPUT section and
choose the relevant digital input tab.
In the MADI optical and MADI coaxial tabs, two toggle switches can be pushed and held to inspect
either channels 1-32 or channels 33-64.
In the AVB input tab, one toggle switch per stream can be pushed and held to inspect the relevant
stream.
This feature is temporary and lasts only while the encoder is pushed. Afterwards, the
front panel level meters will show the level of the analog outputs.
On the web remote, each input port can be opened and level meter indicators will appear above the
channel number.
RME M-32 DA Pro User's Guide
8.4. Front Panel Illumination | 29
Advertisement
Table of Contents
