8. STATE Section
The STATE section contains states and settings that are unrelated to audio I/O and clock. It can be used
to configure power supply warnings, presets, dark mode, level meters, and remote control.
A warning (red) is shown when PSU redundancy is activated but only one power supply is active. A
notification (orange) is shown when a preset is modified, no IP address was assigned to the web remote
or any dark mode is active.
8.1. Power State
When facing the front panel, the left power plug corresponds to the left IEC inlet at the
rear.
Representation of the power states on the device
1. Open the power tab in the STATE section
2. The state of each PSU is shown as active if it receives power.
Representation of the power states on the web remote
1. Connect the device by USB or network cable and open the web remote.
2. A click on the Power icon reveals the current state of the power supplies.
8.1.1. Notification of Single Power Failure
A warning can be displayed when one of two connected power sources fails.
RME M-1610 Pro User's Guide
This icon in the STATE section informs the user which of the two IEC inlets
receive power. It is a realtime representation of the current power state, with
an inactive power supply shown in grey.
8. STATE Section | 26