Table of Contents
Advertisement
In order to lock the device, proceed with the following steps:
1. Open the lock tab in the STATE section (see Section 2.3, "Use of the Display and Encoder").
2. (optional) Set Code: enter a four to six digit code with the encoder.
3. (optional) Activate the Auto Lock toggle to lock after one minute.
4. (optional) Select Lock Device Now to lock immediately.
Remember or write down the code shown in SET CODE. It is not possible to unlock the
device without this code. A unique secondary code (PUK) can be obtained from RME
Support upon request with a proof of purchase and device serial number.
To delete the code, move the cursor on the code and push the encoder. "No code" will be displayed.
The device can only be locked and unlocked at the front panel. These controls are not accessible
remotely.
RME M-1610 Pro User's Guide
8.3. Device Lock | 30
Advertisement
Table of Contents
