Table of Contents
Advertisement
To mute the phones output using the web remote:
1. Press the mute button in the Phones output channel.
10.2.5. Using Phones Out as a Balanced Line Output
The headphone output can operate as a mono balanced line level output. This may for example be useful
when an active talkback speaker with symmetrical input is connected to the 12Mic.
To activate balanced output mode on the device:
1. On the main screen, press the PHONES button to access phones output settings.
2. Press the PHONES button to access phones output settings.
3. Confirm the current gain by pressing the encoder, then turn the encoder to navigate to "Mode".
4. Push and turn the encoder to activate "balanced", push again to confirm. The channel that was routed
to the left phones output will now be applied to both tip and ring of a TRS connector, the phase being
inverted on the ring.
To toggle balanced output mode using the web remote:
1. Open the phones output channel.
2. Press the BAL button to switch the channel to balanced out. The channel that was routed to the left
phones output will now be applied to both tip and ring of a TRS connector, the phase being inverted
on the ring.
10.3. MADI Outputs
The MADI outputs of the M-1610 Pro are always active. If no routing is configured, an empty stream is
sent that can be used for clocking. The state without routing is represented with a light-green Status
Indicator.
For instructions on how to create a routing to the MADI Output, see Section 10.1, "Routing Signals to the
Outputs".
10.3.1. Setting the Output Channel Format and Frame Pattern
Depending on the requirements of the receiver, it is possible to change the channel format and frame
pattern of the outgoing MADI streams.
49 | 10.3. MADI Outputs
RME M-1610 Pro User's Guide
Advertisement
Table of Contents
