Table of Contents
Advertisement
Single speed
A sampling rate of 44.1 kHz or 48 kHz (compare double speed and quad speed).
Word Clock
An electrical square wave signal transported over coaxial 75 Ohm terminated cables. It is used to
synchronize the receiving device (slave, word clock input) to the sending device (master, word
clock output).
12.1. Regulatory Compliance
12.1.1. CE Compliance
This device has been tested and found to comply with the limits of the European Council Directive on the
approximation of the laws of the member states relating to electromagnetic compatibility according to
RL2014/30/EU, and European Low Voltage Directive RL2014/35/EU.
12.1.2. FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Shielded cables must be used with this unit to ensure compliance with the Class B FCC limits.
Responsible Party in USA: Synthax United States, 6600 NW 16th Street, Suite 10, Ft Lauderdale, FL 33313
T.:754.206.4220
Trade Name: RME, Model Number: M-1610 Pro
61 | 12.1. Regulatory Compliance
RME M-1610 Pro User's Guide
Advertisement
Table of Contents
