Understand The Hmi Menu Tree; Overview; Default Display Under Normal Operation Condition - NR Electric PCS-9611 Instruction Manual

8 Human Machine Interface
The button is used to select the control mode of the circuit breaker. Press it down, the
R
remote control mode is selected and the LED "R" is on; press it up, the local control
L
mode is selected and the LED "L" is on.

8.2 Understand the HMI Menu Tree

8.2.1 Overview

In this section, the main layout of the menu which is shown on the LCD of the local human
machine interface (HMI) will be described in detail.

8.2.2 Default Display under Normal Operation Condition

The default display on the LCD is shown as below when the device is in normal situation.
The first line shows the time synchronization state and the current time of this relay. The sign "S"
on left-top side means this relay receive the clock synchronization signal correctly; if there has
nothing on left-top side, it means the time synchronization is not correct. The current time format of
this relay is "yyyy-mm-dd hh:mm:ss".
The middle part of the LCD shows the measurement for the protection.
The last line shows the last section of the IP address and the setting group number. The battery
sign on the left-bottom is used to indicate the ready state of the auto-recloser. When the battery
sign is solid ( ), it means that the auto-recloser is ready; when the battery sign is empty ( ), it
means that the auto-recloser is blocked; and when the battery sign is half solid ( ), it means that
the auto-recloser is in reclaiming procedure.
When the default screen is being shown, press key "▲" to enter the main menu of this relay.
8-4
S 2011-01-25 11:18:25
Ia
Ib
Ic
3I0_Cal
3I0_Ext1
Addr 188
Figure 8.2-1 Default display in normal situation
Measurements
Status
Records
Settings
Print
Local Cmd
Figure 8.2-2 Main menu display of this relay
Date: 2014-04-08
1.238 A
1.242 A
1.239 A
0.004 A
0.003 A
Group 01
PCS-9611 Feeder Relay