Network Dsp Module (Nr4126); Analog Output Module (Nr4411) - NR Electric PCS-9611 Instruction Manual

6 Hardware
10 BI_07
11 BI_08
12 BI_Opto4-
13 BI_09
14 BI_10
15 BI_Opto5-
16 BI_11
17 BI_12
18 BI_Opto6-
19 BI_13
20 BI_14
21 BI_Opto7-
22

6.9 Network DSP Module (NR4126)

The network DSP module is applied in a digitalized substation for receiving or transmitting the
GOOSE information. This module provides 2 optical Ethernet ports only with GOOSE protocol.
The view of the network DSP module is shown in Figure 6.9-1.

6.10 Analog Output Module (NR4411)

The analog output module contains four 4~20mA or 0~10V DC analog output channels for
outputting the metering values (such as current, active power etc.) of this relay to the monitoring
and control system (such as DCS).
The output type (4~20mA or 0~10V) and the corresponding maximum value of each analog output
6-18
The No.7 programmable binary input.
The No.8 programmable binary input.
The common negative connection of the BI_07 and BI_08.
The No.9 programmable binary input.
The No.10 programmable binary input.
The common negative connection of the BI_09 and BI_10.
The No.11 programmable binary input.
The No.12 programmable binary input.
The common negative connection of the BI_11 and BI_12.
The No.13 programmable binary input.
The No.14 programmable binary input.
The common negative connection of the BI_13 and BI_14.
Not used
NR4126
1
3
NR4126D
Figure 6.9-1 View of the network DSP module
Date: 2014-04-08
2
4
TX
RX
TX
RX
PCS-9611 Feeder Relay