Foreseeable Misuse; Personnel Requirements - CP Autosport SetupWizzard Operating Manual

Contents
2.1.1 Structural alterations to the measuring system
Construction and manufacturer's acceptance are based on the German Product Safety Act
(ProdSG). The measuring system is not allowed to be converted or otherwise altered
without prior written permission from CP Tech GmbH.
Any breach of this causes the measuring system to lose its EC conformity. Such a breach
absolves the manufacturer of the measuring system from warranty. This also applies to
welding work on components.
Any parts not in a perfect state must be replaced immediately.
Use original spare/wearing/accessory parts only. These parts have been specifically
designed for the measuring system. For parts from other sources there is no guarantee
that they have been designed and manufactured in line with load and safety requirements.
Parts and special features not delivered by CP Tech GmbH have not been released for use
with the measuring system.
2.1.2

Foreseeable misuse

Any use exceeding the concept of intended use and/or other use of the measuring system
can lead to severe injuries.
–
Only use the measuring system for its intended purpose.
2.2

Personnel requirements

The measuring system is only allowed to be operated, maintained, and repaired by persons
who have been qualified and/or trained for this. These persons must know the operating
manual and act in accordance with it. The respective authorizations for personnel must be
defined clearly.
Personnel require the following qualifications for the various activities:
Qualified, instructed personnel (in this case, e.g., automotive mechatronics technicians)
Qualified personnel are able to do their work and recognize/avoid potential hazards on their
own as a result of their training, knowledge and experience and their familiarity with
regulations.
Electrical specialists
Electrical specialists are able to work on electrical equipment and recognize/avoid potential
hazards on their own as a result of their training, knowledge and experience and their
familiarity with standards and regulations.
Electrical specialists have been trained for their specific point of deployment and know the
relevant standards and regulations.
Wheel alignment system SetupWizzard
7