Introduction; Unpacking The Series 1 - GE Moisture Image Series 1 Startup Manual

Introduction

Unpacking the Series 1

Installation
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Users typically install the Moisture Image Series 1 as part of a
complex process system, which includes components such as filters,
pumps, and pressure regulators. In such an environment, probes and
other parts of the system may be subjected to environmental hazards,
such as high temperature, pressure extremes, corrosive elements and
mechanical vibrations.
This section contains information and instructions for installing the
Series 1 into a process system taking into account all of the above
factors. The following section describes how to set up and connect it.
If you have questions about applications or installation, call an
applications engineer. The toll-free phone number is 1-800-833-9438
(within the USA) or 781-899-2719 (outside the USA).
To ensure the safe operation of this unit, you must
install and operate the Series 1 as described in this
user's manual. In addition, be sure to follow all
applicable safety codes and regulations for
installing electrical equipment in your area.
Before beginning the installation, unpack the unit and make sure all
the parts and documentation listed on the packing slip are included.
The packing slip may not list the Calibration Data Sheet(s), which are
usually packed in the plastic storage case with the moisture, oxygen,
and pressure probes. You may also find the Calibration Data Sheet(s)
in an envelope taped to the Series 1. There should be one Calibration
Data Sheet for each probe. Staple the Calibration Data Sheets to the
Program Information List supplied in Appendix A and store them in a
safe place.
Be sure to inspect each piece of equipment, including the sample
system, for evidence of mishandling. If anything has been damaged,
report this to the carrier and to GE Panametrics immediately. You
should leave the plastic caps on the probes and the pressure
transmitters when they are not installed in the process stream.
If anything is missing, contact GE Panametrics immediately.
!WARNING!
April 2004
1-1