Entering or Changing
Probe Configuration
Data
Initial Setup
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
See Figure 2-14 on page 2-26 for a menu map.
1. From the Probe Configuration Menu (Table 2-1 on page 2-7),
move the pointer to the channel and probe you want to select. The
arrow will only move to installed channels.
2. Press [YES].
3. The possible probe types appear on the message line at the bottom
of the screen. Table 2-2 shows the available probe types.
If you choose to enter a constant for moisture (Kh), temperature (Kt),
or pressure (Kp), you must enter a constant value in the User Constant
Menu. See Entering Constants and User Functions in Chapter 3 of
the Programming Manual for instructions.
4. Move the brackets to the correct probe type, then press [YES]. The
selected probe type displays.
5. Repeat Steps 1 through 4 for each channel.
6. To exit, press the DONE menu key until Main Menu appears on
the message line.
Note: You can only select probes for an installed channel.
If you are only using Moisture Image Series probes, proceed to
Displaying Measurements on page 2-21. If you are using any other
type of input device, proceed to Entering Calibration Data
on page 2-11.
April 2004
2-9
Need help?
Do you have a question about the Moisture Image Series 1 and is the answer not in the manual?