Piper SARATOGA PA-32-301 Maintenance Manual page 90

7
SKETCH B
PIPER AIRCRAFT
PA-32-301/301T
*MAINTENANCE MANUAL
COMPONENT LUBRICANT
1. ENGINESUMP
2. CARTRIDGE TYPE OIL FILTERS
3. AIR FILTERS
4. PROPELLER ASSEMBLY
5. ENGINE CONTROL AN ENVIRONMENTAL
CONTROL PIVOT POINTS
6. FRESH AIR VENT SHAFTS
7. ALTERNATOR IDLER PULLEY
BEARING
MIL-L-6082
LUBRICATING OIL.
AIRCRAFT RECIPRO-
CATING ENGINE
(PISTON) GRADE AS
SPECIFIED, SAE 50
ABOVE 60 F AIR
TEMP., SAE 40 30*
TO 90
°
F AIR TEMP.,
SAE 30 00 TO 70° F
AIR TEMP., SAE 20
BELOW 10 F AIR
TEMP.
MIL-G-23827
MIL-L-7870
MIL-G-7711
MIL-G-81322
FREQUENCY
50 HRS
50O RS
50 HRS
100 MRS
100 HRS
500 HRS
100 HRS
SPECIAL INSTRUCTIONS
1740
I.
AIR FILTER - TO CLEAN FILTER,
TAP GENTLY TO
REMOVE DIRT PARTICLES. DO NOT BLOW OUT
WITH COMPRESSED AIR OR USE OIL.
REPLACE
FILTER IF PUNCTURED OR DAMAGED.
2. INTERVALS BETWEEN OIL CHANGES CAN BE
INCREASED AS MUCH AS 100% ON ENGINES
EQUIPPED WITH FULL FLOW (CARTRIDGE
TYPE)
OIL FILTERS
- PROVIDED THE ELEMENT IS
REPLACED EACH 50 HOURS OF OPERATION.
3. PROPELLER - REMOVE ONE OF THE TWO GREASE
FITTINGS FOR EACH BLADE. APPLY GREASE
THROUGH FITTING UNTIL FRESH
GREASE
APPEARS AT HOLE OF REMOVED
FITTING.
NOTE
SEE LYCOMING SERVICE INSTRUCTIONS NO. 1014
SKETCH A
FOR USE OF DETERGENT OIL
Figure 12-9. Lubrication Chart (Power Plant. Propeller & Control Pivot Points)
12-28-00
Page 12-26
Revised: August 11. 1983
1D18