Piper SARATOGA PA-32-301 Maintenance Manual page 353

PIPER AIRCRAFT
PA-32-301/301T
MAINTENANCE MANUAL
REMOVAL AND INSTALLATION OF LANDING LIGHT.
1. Remove the screw securing the clamp to the bottom of the lamp.
2. Pull the lamp out and remove the two electrical leads connected to it.
- NOTE -
Take note of the wire placement on the lamp to facilitate
reinstallation.
3. To install the lamp. reconnect the electrical leads and insert the lamp into position. then position the
clamp at the bottom and secure with appropriate screw.
ROTATING BEACON.
REMOVAL.
1. Loosen screw securing clamp around rotating beacon lens. Remove clamp and lens.
2. Remove light bulb from bayonet socket.
-NOTE -
To remove complete rotating beacon assembly, remove screws
securing it to fin tip. Next pull rotating beacon assembly out and
disconnect the electrical leads. Take note of their placement to
facilitate reinstallation. Rotating beacon assembly can now be
removed.
INSTALLATION.
1. Install light bulb in bayonnet socket.
2. Replace lens and clamp and secure by tightening screw on clamps.
ANTI-COLLISION LIGHT (STROBE).
The lights are located on each wing tip in the same assembly with the navigation lights. They are rated to
flash at approximately 50 times a minute.
REMOVAL OF WING TIP STROBE LIGHT.
1. Remove the screw securing the navigation light cover and remove cover.
2. Remove the three screws securing navigation light bracket assembly and pull out.
3. Remove the strobe lamp by cutting the wires on the lamp beneath the mounting bracket.
4. Remove the defective lamp.
5. Remove and discard the plug with the cut wires from its electrical socket.
33-43-01
Page 33-06
Revised: August 11. 1983
2D12