Piper SARATOGA PA-32-301 Maintenance Manual page 343

PIPER AIRCRAFT
PA-32-301/301T
MAINTENANCE MANUAL
NOSE GEAR FAIRING REMOVAL AND INSTALLATION. (Refer to Figure 32-17.)
1. Remove the nose wheel fairing as follows:
A. Remove the four bolts (two on each side) securing the nose gear fairing to the strut assembly.
B. Remove the screws securing the forward and aft fairing cover assemblies to the nose gear fairing.
C. Slide the fairing up on the strut assembly to allow access to the nose wheel assembly.
D. Remove nose wheel as described in Removal and Disassembly of Nose Wheel.
E. Turn the fairing sideways and slide down and off of fork assembly.
2. Remove the nose gear strut fairing as follows:
A. Remove the screws and washers which secure the forward strut fairing to the aft strut fairing.
B. Remove the screws and washers which secure the strut fairings to the fuselage. Remove the strut
fairings.
3. Installation of the nose gear fairing is in reverse of the removal procedure.
-END-
32-82-00
Page 32-31
Revised: August 11, 1983
2D2