Piper SARATOGA PA-32-301 Maintenance Manual page 216

PIPER AIRCRAFT
PA-32-301/301T
MAINTENANCE MANUAL
A282
STOP SHOULD BE LUBRICATED AND FREE
TO SWIVEL WITHOUT EXCESSIVE PLAY
STRAIGHTEDGE
I
Figure 25-1. Seat Back Lock
FLIGHT COMPARTMENT.
RIGGING INSTRUCTIONS - SEAT BACK LOCK AND RELEASE. (Refer to Figure 25-1.
1. Loosen scre s and ascertain that clamps are in a relaxed condition. (Push-pull cable is able to move
within the clamps.)
2. Place a straightedge along the lower surface of bushing of the seat back release.
3. Adiust the push-pull cable by raising or lowering it until the lower surface of the stop assembly is
parallel to the straightedge.
4. Secure the push-pull cable in this position by tightening screws on clamps. The stop should be
lubricated and free to swivel without excessive play.
5. Push on seat back with stop assembly in an engaged position to check engagement. Rotate the seat
back release handle and check for disengagement of seat back.
25-11-00
Page 25-01
Revised: August
11. 1983
1124