Piper SARATOGA PA-32-301 Maintenance Manual page 137

THIS END FOR
HORIZONTAL
MOUNT
PIPER AIRCRAFT
PA-32-301/301T
MAINTENANCE MANUAL
407B
NOTE, 12 NOTCHES 1/8 INCH APART
STARTING AT EACH END.
THIS END FOR
VERTICAL
MOUNT
OIL CHECK PLUG
(TYPICAL TWO SIDES)
Figure 21-11. Compressor and Fabricated Oil Dipstick
REPLACEMENT OF COMPRESSOR DRIVE BELT. (Refer to Figure 21-12.)
1. Remove the old belt by removing the spinner. propeller. nose cowl. engine baffles as required. starter
ring gear assembly and drive belt.
Place the new belt in its appropriate positions on the starter ring gear sheaves.
Reintall the starter ring gear assembly. propeller and spinner.
4. Route the belt to the proper pulley sheave as shown in Figure 21-12.
- CAUTION -
Do not force the belt into the pulley sheave. Remove the idler
assemblies, if necessary, and the alternator lower mounting bolts in
order to install the belt.
21-58-05
Page 21-31
Revised: August 11, 1983
1F17