Piper SARATOGA PA-32-301 Maintenance Manual page 266

PIPER AIRCRAFT
PA-32-301/301 T
MAINTENANCE MANUAL
D. If not previously accomplished, remove the cotter pins securing the cable ends to the pulley
assembly on the torque tube: and the clamps securing the cable housings to the support bracket.
E. Disconnect the selector lever and cable from the selector lever support bracket mounted on the
aft side of the instrument panel.
F. Remove the cable assembly from the tunnel.
3. The jack screw and motor assembly may be removed by the following procedure.
A.
Remove the center seats and floor panels.
B. Disconnect the electrical leads to the motor.
C. If not previously accomplished, remove the nut, washers and bolt securing the screw jack
actuator to the torque tube bellcrank.
D. Remove the nut, washers and bolt securing the jack screw to its mounting bracket. Do not drop
the bushing in the jack screw mounting end.
1. CABLE ASSEMBLY
2. PULLEYS
3 BRACKET - FLAP SELECTOR DETENT
4. FLAP INDICATOR LIGHT ASSY
5. FLAP SELECTOR LEVER ASSY
6 BRACKET
7. RETAINER - TORQUE TUBE
8. COTTER PIN
9. PULLEY - FLAP TORQUE TUBE
SWITCHES
14 CAM - FLAP TORQUE TUBE
15. RELAYS - FLAP ACTUATOR
16 BELLCRANK ASSY
17 COVER -FLAP ACTUATOR
16 FLAP ACTUATOR
17
19. FLAP ACTUATOR MOTOR
20 ACTUATOR MOUNTING
BRACKET
20
Figure 27-24. Electrically Operated Flap System
27-51-04
Page 27-46
1L2 Added: August 9, 1984
1L2