Piper SARATOGA PA-32-301 Maintenance Manual page 334

/
/
PIPER AIRCRAFT
PA-32-301/301T
MAINTENANCE MANUAL
1. BRAKE RESERVOIR
2. RIGHT BRAKE AND RUDDER PEDAL
3. LEFT BRAKE AND RUDDER PEDAL
4. RIGHT BRAKE CYLINDER
5 LEFT BRAKE CYLINDER
6 BRAKE HANDLE
7. HANDLE RELEASE BUTTON
8. MASTER CYLINDER ASSEMBLY
9 TORQUE TUBE
10 RUDDER PEDAL PADS
11. BOLT ASSEMBLY
12 CLEVIS PIN
13. LINE, INLET
II
Figure 32-12. Brake System Installation
ASSEMBLY AND INSTALLATION OF BRAKE ASSEMBLY. (Refer to Figure 32-9.)
I. Lubricate the piston O-ring with fluid M IL-H-5606 and install on piston. Slide the piston in cylinder
housing until flush with surface of housing.
2. Slide the lining pressure plate onto the anchor bolts of the housing.
3. Slide the cylinder housing assembly on the torque plate of the gear.
4. Position the lining back plate between the wheel and brake disc. Install the two bolts to secure the
assembly.
5. Connect the brake line to the brake cylinder housing.
6. Bleed the brake system. (Refer to Bleeding Brakes.)
BRAKE MASTER CYLINDER.
REMOVAL OF BRAKE MASTER CYLINDER (HAND BRAKE). (Refer to Figure 32-12.)
I. To remove the brake master cylinder. first disconnect the inlet supply line from the fitting at the top of
the cylinder and allow fluid to drain from the reservoir and line into a suitable container.
2. Disconnect the pressure line from the fittingon thecylinderand allow fluid todrain fromthe cylinder
line.
3. Disconnect the end of the cylinder rod from the brake handle by removing the cotter pin that safeties
the connecting clevis pin. Remove the clevis pin and spacer washers.
32-43-06
Page 32-22
Revised: August 11. 1983
2C17