Piper SARATOGA PA-32-301 Maintenance Manual page 491

PIPER AIRCRAFT
PA-32-301/301T
MAINTENANCE MANUAL
INSTALLATION OF ENGINE. (PA-32-301.) (Refer to Figure 71-1.)
-CA UTION-
Pre-oil an engine prior to initial start after an engine change,
overhaul or prolonged period of inactivity. This reduces the
possibility of high speed bearing failure resulting from a lack of
lubrication. Refer to the lastest revision of Lycoming Service
Instruction 1241.
I. Attach a one-half ton (minimum) hoist to the engine hoisting straps and swing the engine into
alignment with its attaching points.
2. Insert an engine mount bolt. with washer against head. in the engine mount and slide half of the
mount assembly on the bolt. (Refer to Figure 71-1 for proper shock mount assembly.) Repeat this procedure
for the other three attachment points.
- NOTE -
Shock mount Part No. J-3049-35 or J-7763-1 sandwich must be
positioned on the compression side of the engine lugs, with the upper
mounts on the forward side, and the lower mounts on the aft side.
The part number is stamped on the metalface of the mount. (Refer
to Figure 71-1.)
3. Position the mounting lugs of the engine so that they align with the engine mount attaching points.
then move the engine rearward onto the mounts.
4. Slide onto each mounting bolt a spacer and the forward half of the mount. Install washer and nut. and
torque the nuts of the bolts to 450 to 500 inch-pounds.
5. Connect the alternator leads and secure cable with clamps.
6 Connect the injector line to the flow divider.
7. Connect the manifold pressure line at the right rear side of the engine.
S. Connect the static and fuel flow line at the right rear engine baffle.
9. Connect the oil pressure line.
10. Install the line fitting in the vacuum pump and install lines.
11. Connect the tachometer drive cable.
12. Connect the oil temperature lead.
13. Connect the engine vent tube.
14. Connect the oil cooler lines to each oil cooler.
15. Connect the magneto "P" leads. Check that magneto switch is "OFF."
16. Connect the fuel pump supply and vent line.
17. Install the injector.
18. Connect the throttle and mixture cables to the injector. Check adjustment of the control.
19.
Connect the heater hose to the muffler.
20.
Check adjustment of the alternate air door.
21.
Connect the governor control cable and secure with clamps.
22. Connect the starter positive and ground leads and secure cables with clamps.
23. Secure the ignition harness, lines. hoses, wires, etc. that may be loose.
71-00-06
Page 71-13
Revised: August 9. 1984
2J8