Installing Wired Indoor Sensor - Honeywell Home T10 Pro RedLINK Manual

T10 PRO SMART THERMOSTAT WITH REDLINK
Up to 20 of these optional indoor sensors can be used with
the T10 thermostat. These sensors can be used to sense
temperature from a different location than the thermostat,
average temperature from multiple locations, or control
the temperature based on sensor priority (through
scheduling, manually selecting priority sensors, or
prioritizing active rooms.
The T10 can prioritize active rooms using the motion
detectors in the indoor sensors.
Fig. 31. C7189R2002-2 indoor sensor 2 pack
Placement Tips
• DO place about 5 feet above the floor.
• DO place on inside walls.
• DON'T place behind furniture or doors.
• DON'T place in direct sunlight.
• DON'T place above air vents.
See Fig. 32.
Fig. 32.
These sensors can be linked to the thermostat when doing
the initial Installer setup or at a later date.
33-00462—01
M37793
5ft
1.5m
MCR37792
14
• During initial installer setup, the thermostat will offer
setup options under "RedLINK Devices" for "Add
device" or "Set up later".
• To add a sensor after initial setup has been done, select
the menu icon, then "Devices & Sensors", then "Add".
— The display screen will walk you through linking
and naming the sensor.
Installing RedLINK indoor sensors
C7189R2002 Wireless Indoor Sensor
Use the following steps to mount the sensor.
1. Remove the wallplate and mount it 4 to 6 feet above
the floor on an interior wall. Drill 3/16-inch holes for
drywall, 7/32-inch for plaster.
2. Attach sensor securely to wallplate as shown.
Fig. 33.
The thermostat will prompt you to connect RedLINK
devices during initial setup. If the sensors were not
connected to the thermostat at that time:
1. Open the Menu
2. Tap "Devices & Sensors"
3. Tap "Add"
4. Follow the on-screen instructions
1
Fig. 34.

Installing Wired Indoor Sensor

C7189U1005 (10K) Wired Indoor Sensor
ISU setting 5000 on page 23.
Use the following steps to mount the sensor:
M37818
2 3
Devices
& Sensors
Add
MCR37791