Installation; Mounting - Honeywell Home T10 Pro RedLINK Manual

T10 PRO SMART THERMOSTAT WITH REDLINK
SYSTEM INSTALLATION
When Installing This Product...
1. Read these instructions carefully. Failure to follow
the instructions can damage the product or cause a
hazardous condition.
2. Check the ratings given in the instructions to make
sure the product is suitable for your application.
3. Installer must be a trained, experienced service
technician.
4. After completing installation, use these instructions
to verify the product operation.
Finding Your Password (Date Code)
You will need the thermostat password to:
• Add or remove RedLINK accessories
• Make changes to Installer Setup
• Perform an Installer Test
• Reset Thermostat to Factory Default Settings
To find the password (date code) Press the menu (three
horizontal lines) Scroll down and select "Dealer
Information".
CAUTION
Electrical Hazard.
Can cause electrical shock or equipment
damage.
Disconnect power before wiring.
Selecting Thermostat Location
Install the thermostat about 5 ft. (1.5m) above the floor in
an area with good air circulation at average temperature.
See Fig. 6.
NO
NO
[1.5 METERS]
Fig. 6. Selecting thermostat location
Do not install the thermostat where it can be affected by:
— Drafts or dead spots behind doors and in corners
— Hot or cold air from ducts
— Radiant heat from sun or appliances
— Concealed pipes and chimneys
33-00462—01
YES
NO
5 FEET
M37812
— Unheated (uncooled) areas such as an outside wall
behind the thermostat
UWP Mounting System Installation
1. Open package to find the UWP. See Step 1 in Fig. 7.
2. Position the UWP on the wall. Level and mark hole
positions. See Step 2 in Fig. 7.
Drill holes at marked positions, and then lightly tap
supplied wall anchors into wall using a hammer.
Drill 7/32" holes for drywall.
3. Pull the door open and insert wires through the wir-
ing hole of the UWP. See Step 3 in Fig. 7.
4. Place the UWP over the wall anchors. Insert and
tighten mounting screws supplied with the UWP. Do
not over-tighten. Tighten until the UWP no longer
moves. Close the door. See Step 4 in Fig. 7. Use 3x
supplied screws #8 1-1/2".
1 1 1
3 3 3
Optional Decorative Cover Plate

Installation

Use the Optional Cover Plate when:
• Mounting the thermostat to an electrical junction box
• Or when you need to cover paint gap from the old
thermostat.
5. Separate the Junction Box Adapter from the Cover
Plate. See Step 5 in Fig. 8.
6. Mount the Junction Box Adapter to the wall or an
electrical box using any of the eight screw holes.
Insert and tighten mounting screws supplied with
Cover Plate Kit. Do not over-tighten. Make sure the
Adapter Plate is level. See Step 6 in Fig. 8. Use 2x
supplied screws #6 5/8".
7. Attach the UWP by hanging it on the top hook of the
Junction Box Adapter and then snapping the bottom
of the UWP in place. See Step 7 in Fig. 8.
8. Snap the Cover Plate onto the Junction Box Adapter.
See Step 8 in Fig. 8.
6
2 2 2
4 4 4
M37786
Fig. 7.