Honeywell Home T10 Pro RedLINK Manual page 16

T10 PRO SMART THERMOSTAT WITH REDLINK
Fig. 39.
CAUTION
Electrical Interference (Noise) Hazard.
Can cause erratic system operation.
Keep wiring at least one foot away from large
inductive loads such as motors, line starters,
lighting ballasts and large power distribution
panels.
Use shielded cable to reduce interference when
rerouting is not possible.
IMPORTANT
Erratic temperature readings from a sensor can
occur as a result of any of the wiring practices
described below. Avoid these practices to assure
correct operation. Use shielded cable to reduce
interference if rerouting of sensor wiring is not
possible.
— Be sure wires have a cable separate from the ther-
mostat cable.
— Do not route temperature sensor wiring with build-
ing power wiring, next to control contactors or near
light dimming circuits, electric motors or welding
equipment.
— Avoid poor wiring connections.
— Avoid intermittent or missing building earth
ground.
33-00462—01
Installer setup (new installation)
1. After the thermostat has powered up, touch "GET
2. After selecting the correct option for each setting,
3. To see a list of all setup parameters, go to "Installer
4. To finish setup and save your settings, TOUCH
Installer setup (revising settings)
If this is not a new installation and you want to access the
Installer setup to change settings:
1. 1. Touch the menu icon (3 horizontal lines at bottom
2. Scroll down and touch "Thermostat Information".
3. Write down the date code from that screen. The
4. Scroll down until "installer Options" is shown. Touch
M7514
5. Select "installer Setup".
6. After selecting the correct option for each setting,
7. To see a list of all setup parameters, go to "Installer
8. To finish setup and save your settings, TOUCH
16
STARTED" on the thermostat.
Touch NEXT at the bottom of the display to advance
to the next option.
setup (ISU)" starting on page 17. The thermostat dis-
plays the ISU name.
"Done" in the upper left of display
of display)
touch the left arrow at top of display to go to previ-
ous screen.
"installer options" and enter date code.
Touch NEXT at the bottom of the display to advance
to the next option.
setup (ISU)" starting on page 17.
"Done" in the upper left of display
Installer Options
Fig. 40.
MCR37796