Wi-Fi Setup - Honeywell Home T10 Pro RedLINK Manual

T10 PRO SMART THERMOSTAT WITH REDLINK
Installer Setup
ISU # Name
14010 Clock Format
14015 Daylight
Savings Time
14020 Indoor
Temperature
Display Offset
14020 Indoor
Humidity
Display Offset
15000 Dealer
information

Wi-Fi setup

During the initial installation, after the Installer setup the
thermostat will prompt you to set up Wi-Fi and guide you
through the steps. if you are setting up Wi-Fi after the
initial installation has already been done, follow the below
steps:
1. Select the main menu icon
Fig. 41. Main menu icon.
2. Then select Configuration - Wif-Fi
3. There is a slider labeled "Enable Wi-Fi". Make sure
this is set to the right.
4. Touch "Choose Network".
5. After a brief delay, the thermostat should show the
available networks. Choose your home network from
the list.
33-00462—01
Table 5. Installer Setup (ISU)
Settings
• 12 Hour Clock
• 24 Hour Clock
• No
• Yes
-3° F to 3° F in 1° F
increments
(-1.50° C to 1.50° C in
.5° C increments)
-12% to 12% (in 1%
increments)
Company
Phone
Website
Email
Contractor Pro -
number
MCR37797
28
Default
12 Hour Clock
Yes Set to Off in areas that do not follow Daylight
Saving Time.
0° F 0° F - No difference in displayed
(0.00° C) temperature and the actual room
temperature.
The thermostat displays up to 3°F (1.5°C)
lower or higher than the actual measured
temperature.
0° F 0% - No difference in displayed humidity
and the actual room humidity.
The thermostat displays up to 12% lower or
higher than the actual measured humidity.
Touch each individual category to enter the
information. If an alert or notification
appears on the screen, the customer will be
shown the dealer information so they know
who to contact.
Enter your company's Contractor PRO
account number to receive bonus points for
every T10 Pro Smart thermostat you install.
Your account number is an 8 digit number
which includes a leading zero (example
01234567).
6. If this is a secure network, it should prompt you to
"Enter Wi-Fi password". After a brief delay the dis-
play should show "Success! Your thermostat suc-
cessfully connected to the network." Press the "OK"
button.
NOTE: If you did not successfully connect to the network,
attempt to:
7. Download the Honeywell Home app from the App
store or Google Play.
8. Open the Honeywell Home app. Tap SET UP NOW as
shown here to continue. Tap INSTALL A DEVICE and
follow the prompts to continue. The app will walk you
through the rest of the setup.
Fig. 42. Set up now.
Notes
MCR37798