Replacement Procedure - Omron NX Series User Manual

7 Maintenance
7-3-3

Replacement Procedure

NX701-Z£00
Replace the SD Memory Card for the NX-series Controller.
Refer to Installing and Removing the SD Memory Card in the NX-series CPU Unit Hardware User's
Manual (Cat. No. W535) to remove the old SD Memory Card and replace it with a new one.
NY5£2-Z£00
This section describes the replacement procedure of the expanded storage (SSD) in the drive bay A of
the NY-series Controller. After you replace the SSD on the NY-series AI Controller, you need to format
the new SSD. Use the Rescue Disk Utility to format the SSD.
The Rescue Disk Creator to install the Rescue Disk Utility is installed in Windows of the AI Controller.
Step Item
Step Verifi-
1 cation
and
prepa-
ration
prior
to the
re-
place-
ment
Step SSD
2 re-
place-
ment
7-6
Make sure that you prepare an USB storage device to install the Rescue Disk Utility.
Next, refer to Backing up and Recovering the Industrial PC System in the NY-series Industrial
Panel PC / Industrial Box PC Setup User's Manual (Cat. No. W568), and install the Rescue
Disk Utility into the USB storage device.
At this time, check to see if the version of Rescue Disk Creator that you will use to install the
Rescue Disk Utility is version 1.1.2004.0100000040 or higher. You can check the version of
Rescue Disk Creator by opening Control Panel and selecting Programs and Features. If the
installed version is older than this version, download the latest version of Rescue Disk Creator
from the OMRON website and install it to your NY-series AI Controller.
Refer to Drive Replacement in the NY-series Industrial Box PC Hardware User's Manual (Cat.
No. W556) or the NY-series Industrial Panel PC Hardware User's Manual (Cat. No. W557) and
replace the expanded storage (SSD) in Drive Bay A.
NX/NY-series Artificial Intelligence Machine Automation Controller User's Manual (W594)
Description