Problems When Installing Os - NEC Express5800 Series Maintenance Manual

Chapter 1 Maintenance
[?] Unable to start EXPRESSBUILDER from Internal Flash Memory
 Did you press <F3> key to start EXPRESSBUILDER from Internal Flash Memory while POST was being
executed?

When the following message, "Press <F2> Setup, <F3> Internal Flash Memory, <F4> ROM Utility,
<F12> Network", appears on screen after starting up, press <F3> to start EXPRESSBUILDER from
Internal Flash Memory.
 Is there the message, "<F3> Internal Flash Memory", displayed on POST screen?

If not, make sure that Internal Flash Memory is connected correctly by referring to Chapter 2 (6. Details
of EXPRESSBUILDER).
[?] The following message appears and EXPRESSBUILDER failed to start
 Did you press <Enter> key consecutively twice or more when selecting "Os installation *** default ***" ?

Press <Enter> key on the above screen for selecting "Windows Setup [EMS Enabled]" to start
EXPRESSBUILDER.
5.3

Problems When Installing OS

[?] Unable to install OS
 Is the Hard Disk Drive properly installed?

Make sure that the Hard Disk Drive is installed securely and that cables are properly connected.
 Did you configure the RAID Controller?

For the RAID System, a RAID Configuration Utility (WebBIOS) to properly configure the RAID Controller
before installing OS.
 Did you create a Logical Drive?

For the RAID System, create a Logical Drive a RAID Configration Utility (WebBIOS) to install OS.
[?] Unable to install Windows
 Have you checked precautions for installation?

For Windows Server 2003, refer to "Installation Guide (Windows)".
24
Express5800/E120d-1 Maintenance Guide
5. Troubleshooting