Configure Expressbuilder Settings - NEC Express5800 Series Maintenance Manual

Chapter 2 Convenient Features
6.4

Configure EXPRESSBUILDER Settings

EXPRESSBUILDER Settings can be configured from Top Menu (described in Chapter 2 (6.2 Menu) - (2) Top
Menu), as follows.
(1) Load a driver into EXPRESSBUILDER
A driver stored in a removable media can be loaded. Use this function only for drivers provided by NEC.
(2) Manage Internal Flash Memory
Internal Flash Memory can be managed by using commands described below.
a) Confirm the connection of Internal Flash Memory
Checks if Internal Flash Memory is installed and accessible.
POST message is changed depending on the execution result of this command.
If the connection of Internal Flash Memory is recognized, the commands b) and c) below can be executed.
Connected:
Not connected: EXPERSSBUILDER cannot be started by pressing <F3> key (<F3> Internal Flash
b) Initialize Internal Flash Memory
Clears the data in Internal Flash Memory and initializes (formats) it.
Be careful that all data in Internal Flash Memory is deleted.
c) Update Internal Flash Memory
Copies EXPRESSBUILDER from EXPRESSBUILDER DVD or other media provided by NEC to Internal
Flash Memory.
The data is overwritten and all previous data is cleared.
116
Note
The below commands are not available when EXPRESSBUILDER is started from
Internal Flash Memory.
EXPERSSBUILDER can be started by pressing <F3> key (<F3> Internal Flash Memory
is displayed on the screen).
Memory is not displayed on the screen).
Tips
The parameter file and RAID configuration data are retained.
Express5800/E120d-1 Maintenance Guide
6. Details of EXPRESSBUILDER