NEC Express5800 Series Maintenance Manual page 81

Chapter 2 Convenient Features
Item
Access Limitation
Limitation Type
IP Address
Service
HTTP
HTTP Port Number
HTTPS
HTTPS Port Number
SSH
SSH Port Number
*1: You can change this parameter only if your allows it.
*2: After you change parameter value, resetting of BMC may be required depending on the server. When set to
"Shared BMC LAN", the management LAN port is disabled. When set to "Shared BMC LAN", the system (OS)
LAN port also transmits or receives data. Thus, the network performance may be reduced due to load of
system LAN (or BMC LAN).
*3: If an illegal value is specified for subnet mask, an error message is displayed and setting is disabled.
*4: Can be changed only when DHCP is set to "Disable".
*5: Can be changed only when DHCP is set to "Enable".
*6: Host Name should be within 63 characters.
Acceptable characters are: alphanumeric, hyphen (-), underscore (_), and period (.).
*7: Host Name and Domain Name should be within total of 255 characters.
Acceptable characters are: alphanumeric, hyphen (-), underscore (_), and period (.).
*8: The range of IP address to "Allow" or "Deny" access is delimited by ",(Comma)". With regard to the setting of
"Deny" access, "*(Asterisk)" can be described as a wild-card. (ex: 192.168.1.*,192.168.2.1,192.168.2.254)
*9: Can be specified when Access Limitation Type is "Allowed Address" or "Deny Address". The length must not
exceed 255 characters.
*10: If HTTP is set to "Enable", HTTPS is changed to "Enable" automatically. You are not allowed to set "Enable" to
HTTP only.
*11: Port number can be specified only when the relevant port is set to "Enable". The port number must be unique.
Description
Select the Access Limitation Type.
Allow All
: Access to BMC is not limited.
Allow Address
: Specify the IP Address that is allowed to access BMC.
Deny Address
: Specify the IP Address that deny to access BMC.
Specify the IP Address to allow or deny to access with BMC.
Enable or disable HTTP service.
*11
Specify the HTTP port number.
Enable or disable HTTPS service.
Specify the HTTPS port number.
Enable or disable SSH service.
*11
Specify the SSH port number.
Express5800/E120d-1 Maintenance Guide
*8 *9
*10
*10
*11
2. BMC Configuration
Default Value
Allow All
Blank
Enable
80
Enable
443
Enable
22
81